Haltech GM GEN III LS1/LS6/GEN IV LS2/LS3 (DBW Retrofit Ready) Elite 2500 Terminated Harness
Haltech GM GEN III LS1/LS6/GEN IV LS2/LS3 (DBW Retrofit Ready) Elite 2500 Terminated Harness
Haltech GM GEN III LS1/LS6/GEN IV LS2/LS3 (DBW Retrofit Ready) Elite 2500 Terminated Harness
Haltech GM GEN III LS1/LS6/GEN IV LS2/LS3 (DBW Retrofit Ready) Elite 2500 Terminated Harness

Haltech GM GEN III LS1/LS6/GEN IV LS2/LS3 (DBW Retrofit Ready) Elite 2500 Terminated Harness

HT-141362

$670.00
/
Shipping calculated at checkout.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

 Suits: Retrofit of a GEN IV LS2/3 DBW throttle body. Common US style Delco/Bosch GM alternator connector. Pre-wired to connect directly to OEM 7 Pin Coil Harness Connector. WBC1/2 CAN O2 Wideband Controller ready (Controller and sensor(s) not included) Manual transmission only.

Includes: Engine harness with fuse block and firewall grommet.

Notes: Please confirm your alternator connector (See the product quick start guide) and order an alternator adaptor if required. (HT-040090 or HT-040091) Ignition coils and harnesses are NOT included, Please order 8 x HT-020102 and/or HT-045657 if required.

IMPORTANT EMISSIONS NOTICE:
In many states, it is unlawful to tamper with your vehicle's emissions equipment. Haltech products are designed and sold for sanctioned off-road/competition non-emissions controlled vehicles only and may never be used on a public road or highway. Using Haltech products for street/road use on public roads or highways is prohibited by law unless a specific regulatory exemption exists (more information can be found on the SEMA Action Network website www.semasan.com/emissions for state by state details in the USA). It is the responsibility of the installer and/or user of this product to ensure compliance with all applicable local and federal laws and regulations. Please check with your local vehicle authority before purchasing, using or installing any Haltech product.

 

RESOURCES

 

The fastest and most cost effective way to wire your race car or engine conversion! Simply connect a handful of labelled wires and this plug and Play product allows you to be up and running in just a few hours.
  • An efficient Haltech Plug'n'Play product that allows you to be up and running in just a few hours.
  • The quick start guide will walk you through installation of the Haltech Plug'n'Play harness into your vehicle.
  • The guide is accompanied by the full ECU manual and Software located on the CD or USB key provided with the ECU to refer to while completing your installation and configuration.
  • This harness when installed in conjunction with a Haltech Elite ECU opens the door to virtually limitless performance modification and tuning of your vehicle.
  • Fully programmable systems allow you to extract all the performance from your engine by delivering precisely the required amount of fuel and ignition timing that your engine requires for maximum output under all operating conditions. 

Recently viewed